Ready Filters Replacement for GE RPWF Fridge Filter, 2-Pack

Ready Filters WF-1410A | Our#: 181721
2 pack
 

Ready Filters Replacement for GE RPWF Fridge Filter

  • Change Every 6 Months
  • 25 - 120 PSI
  • 33 - 100 °F
  • 170 Gallon Capacity
  • 0.5 GPM Flow Rate
As Low As $25.95 Per Filter
In Stock
Ships Today
Est. Delivery By May. 3rd
Choose a quantity

The Ready Filters WF-1410A is designed to replace the GE RPWF filter cartridge.  It is used is used in Bottom-freezer and Side-by-Side refrigerators by GE.  The WF-1410A uses advanced carbon block technology to create better tasting water for drinking and making beverages as well as clean, clearer, healthy ice.  This filter is located in the bottom of the fresh food compartment, or in the left hand door. 

Note: This filter will not replace the GE RPWFE filter

Features:

  • Cost effective alternative to factory original product
  • Easy installation and operation
  • Helps reduce chlorine taste and odor
  • Helps reduce contaminants found in tap water and improves its quality
  • Certified to the NSF/ANSI 42 Standard for the reduction of chlorine taste and odor
  • Filter has been tested and certified to NSF/ANSI 372 for lead free compliance

Filter Location:

Bottom-freezer (BF) refrigerators:
Filter is located in the left hand fresh food door (recessed in door flange) or in the fresh food interior on the left side wall near the top

Side-by-Side (SxS) refrigerators:
Filter is located in the bottom of the fresh food compartment.  Access the filter using the flip cover without moving the vegetable pan


The Ready Filters WF-1410A is compatible with the following obsolete or alternate filter part numbers:

  • AB-9865
  • APF-2600
  • BLZ-33694
  • DWF-36
  • EP-RPWF
  • EWRF1026
  • GFE27GSD
  • GFE29H
  • GFE29HSD
  • GGD
  • GMD
  • GNE26GSD
  • HGD
  • HMD
  • KGD
  • KMD
  • MPF15350
  • OMHM-RP01
  • OPFG3-4P-RPWF
  • PFE27KSD
  • PFE29P
  • PFE29PSD
  • PWE23KSD
  • PYE23KSD
  • PYE23PSD
  • RB-G4
  • RPWF
  • RWF1063
  • RWF3600
  • RWF3600A
  • SSF5160
  • WD-RPWF
  • WF-1410A
  • WF-41699C
  • WSG-4

How To Install The Ready Filters WF-1410A Filter:

  1. Remove old cartridge by gently lifting the filter away from housing until first release, and then lift again to remove.
  2. Align top of filter with cartridge holder and push until cartridge is fully seated.
  3. While continuing to ensure cartridge is fully seated in the holder, gently rotate the filter (inward for BF models and downward for SxS models) until it can no longer rotate.
  4. Run water from the dispenser (approximately 2 gallons or about 5 minutes) to clear any particles and remove air from the system.

Literature