ClearChoice Replacement for WF3CB Refrigerator Water Filter

ClearChoice CLCH122 | Our#: 183006

ClearChoice Replacement for WF3CB Refrigerator Water Filter

  • Change Every 6 Months
  • 20 - 120 PSI
  • 33 - 100 °F
  • 300 Gallon Capacity
  • 0.5 GPM Flow Rate
As Low As $17.99 Per Filter
In Stock
Ships Today
Est. Delivery By Mar. 26th
Choose a quantity

The ClearChoice CLCH122 is a compatible filter replacement for the Frigidaire WF3CB - AKA PureSource3.  It fits refrigerators from Frigidaire, Electrolux and others.  This filter uses its activated carbon technology to deliver healthier and refreshing water and ice. The CLCH122 needs to be changed every six months or 300 gallons (whichever comes first). 


  • Replacement filter for part number WF3CB, PureSource3 and more
  • Easy installation - just slide it in and push until you hear a "click"
  • Can be used in Frigidaire and Electrolux refrigerators
  • Filter length approximately 9-1/4" long
  • Made with pride in the USA

The ClearChoice CLCH122 is compatible with the following obsolete or alternate filter part numbers:

  • 242069601
  • 242086201
  • 706465
  • AP4567491
  • PS3412266
  • WF3CB

How To Install The ClearChoice CLCH122 Filter:

  1. Turn Off the ice maker by raising the wire signal arm.
  2. Remove the filter by pushing on the end/face of the filter.
  3. Slide the old water filter cartridge straight out of the housing and discard it.
  4. Using the alignment guide, slide it gently into the filter housing until it stops against the snap-in connector at the back of the housing.
  5. Push firmly until the cartridge snaps into place (you should hear a click as the cartridge engages the snap-in connector).
  6. Press a drinking glass against the water dispenser while checking for any leaks at the filter housing. Any spurts and sputters that occur as the system purges air out of the dispenser system are normal
  7. After filling one glass of water, continue flushing the system for about four (4) minutes
  8. Turn On the ice maker by lowering the wire signal arm
  9. Press and hold the Water Filter button on the Ice & Water Dispenser control panel for three seconds. When the display changes from Red to Green, the status has been reset