Turn Off the ice maker by raising the wire signal arm.
Remove the filter by pushing on the end/face of the filter.
Slide the old water filter cartridge straight out of the housing and discard it.
Using the alignment guide, slide it gently into the filter housing until it stops against the snap-in connector at the back of the housing.
Push firmly until the cartridge snaps into place (you should hear a click as the cartridge engages the snap-in connector).
Press a drinking glass against the water dispenser while checking for any leaks at the filter housing. Any spurts and sputters that occur as the system purges air out of the dispenser system are normal
After filling one glass of water, continue flushing the system for about four (4) minutes
Turn On the ice maker by lowering the wire signal arm
Press and hold the Water Filter button on the Ice & Water Dispenser control panel for three seconds. When the display changes from Red to Green, the status has been reset
Abe S. said:
"The same product for half the cost. What a deal!"